P2DC0
Battery Charger B Coupler Lock Position Sensor Circuit Intermittent/Erratic
P2DC0 describes lock feedback at the charger B inlet that jumps or drops out for short moments instead of failing steadily. Because the lock state is a release condition for charging, a flickering signal can end a session or stop it from starting even though the plug is held properly. No manufacturer documents P2DC0 publicly. GM's patent US8936482B2 names the consequence of an unconfirmed lock: fast charging is prohibited. As a model on the A side, Mercedes traced a lock position sensor fault (P0D9F00) on the smart electric drive's 22 kW charger to loose low-voltage plugs at that charger (LI54.10-P-067823), with complaints tied to cold or warm components. Worn terminals, a chafed wire at the inlet and water ingress are typical. Steady faults are P2DBC to P2DBF.
Possible causes
- Loose low-voltage plug at the lock actuator or charger high
- Sensor wire chafed near the charging inlet medium
- Water ingress into the inlet or actuator connector medium
Symptoms
- Charging at inlet B stops or fails to start sporadically
- Fault appears only at certain temperatures
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2DC0
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.