OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2DBE

Battery Charger B Coupler Lock Position Sensor Circuit Low

P2DBE means the coupler lock sensor of charger B delivers a voltage below its valid band. No manufacturer documents P2DBE publicly. The A-side code P0DA0 is documented by Mitsubishi for the 2023 Outlander PHEV: with the ignition-controlled supply on, the PHEV-ECU sets it on a low input from the inlet's lock sensor. The repair flow first checks the signal line for a ground short between ECU and lock actuator connector, then checks the sensor itself, which should measure about 16.8 kΩ between its two pins. Damaged harness, the inlet cable assembly with its actuator, or the ECU are the named suspects. Ford also lists P0DA0 among the codes after a broken lock pin (TSB 23-2014). Too high is P2DBF. Charging via inlet B may be refused.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberD / BE

Possible causes

  • Sensor signal line shorted to ground high
  • Lock position sensor with internal short or wrong resistance medium
  • Damaged lock actuator after the plug was pulled while latched medium
  • Faulty sensor input in the control module low

Symptoms

  • Charging at inlet B refused
  • Charging system warning lamp or message

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2DBE

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication