P2DBA
Battery Charging System B High Voltage Interlock Circuit High
P2DBA flags an interlock signal of charging system B that reads too high. A loop fed from a test source and measured at its far end shows a raised level when it is shorted to a supply voltage, or, depending on the circuit, when added resistance or a break lets the measuring input float upward. No manufacturer documents P2DBA publicly. GM checks the A-side loop of the Volt in two states (P0D18): with the 5 V source off, a reading above 24 % of reference counts as a fault, with it on, one above 44 %; both are Type A in the 2011 and 2014 tables. Telling a short to voltage from an open therefore needs both states. The low counterpart is P2DB9. Charging through path B stays blocked.
Possible causes
- Interlock wire shorted to a supply voltage medium
- Added resistance or partial break in the interlock loop medium
- Faulty measuring input in the control module low
Symptoms
- No charging via path B
- Charging system warning message
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2DBA
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.