OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2DB3

Drive Motor A Temperature Sensor C Circuit Low

P2DB3 sets when the sensor C voltage drops below its valid floor. For an NTC probe this would stand for a temperature far beyond any real winding heat, so a short is much more likely than a genuine hot spot: signal lead to ground or motor housing, insulation damaged inside the stator, or a thermistor shorted internally. Mitsubishi, which reads its W-phase coil probe as sensor 3 on the 2023 Outlander PHEV, uses its own code P3056 and the same floor as on the other phases: no more than 0.1 V over half a second. Thinking Electronic rates its stator probes for −40 to 200 °C and tests them at up to 2000 V AC, a reminder that the probe sits in the high-voltage winding. No manufacturer documents P2DB3. P2DB4 is the high side, P2DAE the same fault on sensor B.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberD / B3

Possible causes

  • Sensor C signal lead shorted to ground or motor housing high
  • Probe insulation damaged inside the stator medium
  • Thermistor shorted internally medium

Symptoms

  • Hybrid system warning and check engine light
  • Sensor C reads extremely hot while the other sensors look normal
  • Electric drive power reduced

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P2DB3

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication