P2DAF
Drive Motor A Temperature Sensor B Circuit High
P2DAF is the high-side counterpart: the sensor B voltage rises close to the reference. For an NTC probe that would be an impossibly cold winding, so the controller treats it as an interrupted circuit – broken lead, unplugged or corroded connector, cracked thermistor – or, less often, a short to a supply voltage. A UAES patent on stator sensor diagnosis describes the principle: upper and lower voltage limits sit just inside the supply rails, and a reading outside them counts as a circuit fault before any plausibility logic runs. Mitsubishi's equivalent for the V-phase probe of its Outlander PHEV (2023) is P3052, set once the signal reaches 4.93 V and stays there half a second. No manufacturer publishes P2DAF. The low side is P2DAE. Without sensor B the inverter may hold back torque to protect the winding.
Possible causes
- Open signal or ground lead of sensor B high
- Connector unplugged or terminal backed out, often after drive unit work medium
- Thermistor open or cracked inside the stator medium
- Signal lead shorted to a supply voltage low
Symptoms
- Hybrid system warning or check engine light
- Sensor B shows an implausibly low temperature in live data
- Electric drive power limited
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2DAF
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.