OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2DAB

DC/AC Converter Control Module A Switch B Circuit Range/Performance

With P2DAB, switch B of converter module A – the unit feeding the vehicle's AC sockets – fails a plausibility test. Wiring tests pass, yet switch B does not deliver what was asked of it: it stays closed after an off command, opens under load, or reports a position that disagrees with the measured output. CARB 13 CCR 1968.2 calls for such functional checks on output components. In Ford's patent US11043801B2 the controller opens socket switches on its own – after a timer, above a user current limit or when total power is too high – so a state the module did not expect can also come from this logic. No manufacturer documents P2DAB publicly. A switch that welds shut is the more serious case, because the socket can no longer be switched off; contact wear and moisture are the usual reasons.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberD / AB

Possible causes

  • Contacts of switch B or its relay welded, sticking or worn high
  • Moisture or dirt at the outlet panel of group B medium
  • Load management or software in the converter module, update available low

Symptoms

  • Outlets of group B switch off unexpectedly or cannot be switched off
  • Warning about onboard power in the display
  • Fault appears mainly with high loads connected

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2DAB

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication