OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2DA7

Coolant Heater A Control Module System Voltage

P2DA7 is logged when the electronics built into coolant heater A – the HV heater of a hybrid or EV – see a system voltage outside the window in which it may work. While P2DA5 points to the feed circuit, this code judges the level. High-voltage heaters have a defined range; DBK's 400 V unit, for example, runs from 195 to 450 V DC, and Texas Instruments notes that heater controllers must cope with a varying DC bus and may monitor their supply rails. No manufacturer documents P2DA7 publicly or states whether it rates the HV or the 12 V side. Typical reasons are a strongly discharged or very full traction battery, a weak 12 V battery or a measuring fault in the heater. The heater stays off while the voltage is out of range and usually resumes afterwards.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberD / A7

Possible causes

  • Traction battery voltage at the edge of the heater's range (very low or very high charge) medium
  • Weak 12 V battery or poor ground of the heater electronics medium
  • Voltage measurement inside the heater faulty medium

Symptoms

  • Electric heater temporarily without function
  • Fault occurs with very low or very high battery charge
  • Cabin heat only from the engine of a hybrid

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2DA7

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication