P2DA4
Coolant Heater A Internal Control Module Performance
Coolant heater A here is an electric heater with built-in electronics, usually a high-voltage PTC or wire-element unit that warms coolant for cabin and battery in hybrids and EVs; it is separate from the engine block heater codes P01E8 ff. P2DA4 says that heater's own controller has found a fault in itself – a power switch that shorted, a temperature or current measurement that fails, or a processor error. Texas Instruments describes the usual layout: one controller on the 12 V side for LIN or CAN, one on the HV side that drives the elements and cross-checks current, voltage and temperature. No manufacturer documents P2DA4 publicly; Ford stores the sister code P2DA6 in the module SOBDMC on the F-150 Lightning. The heater is switched off, so expect little heat in electric mode.
Possible causes
- Power switch inside the heater shorted or failed high
- Internal temperature or current measurement faulty medium
- Coolant or moisture inside the electronics housing low
- Software fault in heater or commanding module, update available low
Symptoms
- Little or no cabin heat in electric mode
- Engine of a hybrid runs more often just to supply heat
- Climate system message, usually without check engine light
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2DA4
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.