P2DA3
Gear Shift Control Module B Overtemperature
P2DA3 is a condition code: gear shift control module B reports that its internal temperature exceeds the safe limit. The circuit is fine, the module simply runs too hot. No manufacturer documents P2DA3 or a threshold publicly; Allison's 6th-generation controls, which give module 2 its own performance and communication codes, do not list it. Heat can enter from outside – a selector in a sun-heated console, a mounting close to heater ducts or other warm components – or arise inside, when output stages for display, lock solenoid or illumination draw too much current. A hot unit may reduce its functions until it cools. A code that also appears at normal temperatures points to an internal defect.
Possible causes
- Strong sun load or nearby heat source at the mounting location medium
- Output stage for lock solenoid, display or lighting drawing excess current medium
- Internal defect or faulty temperature sensing in module B medium
Symptoms
- Shifter warning, mainly in hot weather or after long operation
- Second selector temporarily ignores range requests
- Fault disappears after the module has cooled down
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2DA3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.