P2DA2
Gear Shift Control Module B Supply Voltage High
P2DA2 is the over-voltage counterpart of P2DA1: gear shift control module B, the second selector unit of a shift-by-wire system, sees a supply above its permitted maximum. No manufacturer documents P2DA2 publicly or names the limit. Excess voltage usually comes from the charging side – a failed alternator regulator or DC/DC converter, a 24 V jump start, a battery charger left connected during diagnosis – and only rarely from a short between the module feed and a higher-voltage circuit. To protect itself the module may stop accepting inputs. Allison's 6th-generation controls show that a second selector is handled as a unit of its own with separate codes, so a fault there need not disable the first one. Measure charging voltage before replacing anything.
Possible causes
- Alternator regulator or DC/DC converter delivering too much voltage high
- Jump start with 24 V or charger connected during operation medium
- Module feed shorted to a circuit with higher voltage low
- Voltage measurement inside module B faulty low
Symptoms
- Shifter warning in the instrument cluster
- Second selector does not respond, main selector may still work
- Further overvoltage codes in other modules, flickering lights
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2DA2
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.