OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2DA1

Gear Shift Control Module B Supply Voltage Low

With shift-by-wire, the selector the driver touches is an electronic module; module B is a second one, such as a further selector station or a redundant unit. Allison's 6th-generation controls show such a pair: for module 2 they list performance, lost communication, incompatibility and invalid data (P085E, U0291, U0333, U0592), but no supply codes. P2DA1 means the 12 V feed of module B, as measured by the module or the transmission controller, is below its lower limit. No manufacturer documents P2DA1 publicly. Audi's selector lever J587 on 2019–21 A6/A7 shows how much depends on this voltage check: its evaluation logged faults and blocked range selection until new software was loaded. Battery, fuse, feed wire and ground come first.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberD / A1

Possible causes

  • Weak 12 V battery or voltage dip during cranking high
  • Corroded ground, loose connector or high-resistance feed to module B medium
  • Fuse for module B blown or with poor contact medium
  • Voltage evaluation in module software too strict low

Symptoms

  • Shifter warning in the instrument cluster
  • Range selection at the second selector ignored, vehicle stays in P
  • Fault appears together with other low-voltage codes

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2DA1

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication