P2DA0
High Voltage System Performance
P2DA0 is the plausibility code of this group: the high-voltage system is neither clearly too low nor too high, but its readings or behaviour do not fit together. CARB 13 CCR 1968.2 asks for such rationality checks on inputs, stored separately from circuit and range faults. No manufacturer documents P2DA0 publicly. A typical cross-check appears in GM's 2013 eAssist table under P1AEC: with contactors closed, the motor control processor compares its own bus voltage with the pack voltage and the sum of the mid-pack readings and flags a difference of 15 V or 10 V, two trips, Type B. Differing sensors, a high-resistance HV joint, contactor contacts that have burnt or a slow precharge lead there. Power is usually limited.
Possible causes
- Voltage sensors in battery and inverter disagree medium
- High resistance in an HV connector, busbar or fuse medium
- Main contactor contacts burnt or welded medium
- Calibration or software of a controller, update available low
Symptoms
- Hybrid or EV system warning, check engine light
- Reduced drive power or no electric drive
- Fault appears under heavy load or after a long stop
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2DA0
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.