P2D9F
High Voltage System Voltage High
P2D9F is the over-voltage case: the DC voltage on the high-voltage network rises above the permitted maximum. Too much voltage stresses capacitors, power semiconductors and cells, so controllers react within milliseconds by cutting regeneration or charging. No manufacturer documents P2D9F publicly. GM's eAssist table of 2013 gives a comparable check under its own code P1AEE: the motor control processor flags system voltage high when its HV sensor reads more than 150 V or a hardware over-voltage flag is set, two trips, Type B. Typical triggers are strong regenerative braking with a full battery, a contactor opening while the motor still generates, or a drifting voltage measurement. Expect reduced regeneration, limited power and a warning light.
Possible causes
- Regenerative braking or charging while the battery is already full or cold medium
- Contactor or HV connection opening while the motor generates medium
- Voltage measurement in the inverter or controller reads too high medium
- Voltage limits in control software too tight, update available low
Symptoms
- Hybrid or EV system warning and check engine light
- Little or no regenerative braking, more wear on the friction brakes
- Power limited or HV system shut down
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2D9F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.