P2D9D
Starter/Generator Phase W Current Circuit Intermittent/Erratic
P2D9D covers phase W of the starter/generator when its current signal flickers or drops out for moments. The W sensor is one of the two that GM's eAssist belt machine monitors. GM's checks there look at solid failures: below -440 A or above 440 A for 41.6 ms, Type B, and a learned zero offset beyond 30 A while the inverter is off. A brief glitch that never crosses such limits is what an intermittent code is meant to catch. No manufacturer documents P2D9D publicly. Hall sensors around the phase conductors deliver a voltage that follows the current, so a drifting reference, moisture or a cracked solder joint in the electronics can make the reading jump. Steady W faults belong to other codes; U and V intermittent: P2D9B, P2D9C.
Possible causes
- Moisture inside the starter/generator electronics medium
- Cracked solder joint in the sensor path after many heat cycles medium
- Poor contact in the phase W sensor connector medium
Symptoms
- Warning lamp that shows up mostly when the engine is hot or the weather is wet
- Charging through the starter/generator briefly interrupted
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2D9D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.