P2D9C
Starter/Generator Phase V Current Circuit Intermittent/Erratic
P2D9C reports an erratic current signal on phase V of the starter/generator. V is the phase that some designs never measure: in a star-connected three-phase winding the three currents add up to zero, so GM's eAssist table runs sensor checks only on U and W. Other inverters fit a sensor to every phase conductor, often a Hall chip in a ring core whose output voltage follows the current. A system that stores P2D9C therefore evaluates phase V on its own, and an unsteady value there leads to the V sensor, its plug or its leads rather than to the other two phases. No manufacturer documents P2D9C publicly. Drivers notice a sporadic warning and short gaps in stop-start or boost. Neighbours: P2D9B (U) and P2D9D (W).
Possible causes
- Phase V sensor plug not fully latched or with fretting corrosion high
- Intermittent break in the phase V sensor wiring medium
- Phase V current sensor with unstable output low
Symptoms
- Sporadic system warning on the instrument cluster
- Short interruptions of stop-start or boost
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2D9C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.