OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2D97

Starter/Generator Phase Z Current Sensor Circuit Low

P2D97 is the last of the three low codes: the Z-phase current sensor of the starter/generator reports a value under the bottom of its valid window. Because the machine both drives the engine and charges, its phase current is signed, so a low fault stands for an impossible negative reading or a collapsed output, not for a weak current. Z is no mere placeholder: Mazda's bulletin 01-004-25 for its integrated starter generator lists the stator driver circuits in a U-V-W group and a separate X-Y-Z group. No manufacturer documents P2D97 publicly. In GM's eAssist analogue the low codes trip below -440 A after roughly 42 ms, Type B. Suspect a grounded signal lead or a lost sensor supply. High side: P2D94; X and Y low: P2D95, P2D96.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberD / 97

Possible causes

  • Phase Z sensor signal lead shorted to ground or to the machine housing high
  • Sensor supply interrupted by an open wire or a pushed-back terminal medium
  • Phase Z current sensor output stuck at the bottom of its range medium

Symptoms

  • Warning lamp or MIL, typically after the fault has repeated on a second trip
  • Electric boost and recuperation reduced or switched off
  • No automatic engine stop, or restarts via the conventional starter

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2D97

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication