OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2D96

Starter/Generator Phase Y Current Sensor Circuit Low

P2D96 covers the phase Y current sensor of the starter/generator when its signal drops below the valid range, for instance through a short to ground or a missing sensor supply. For the driver the more important part is how the controller reacts: without a trustworthy phase current it will usually limit or stop electric assist, stop-start can be suspended and charging through the machine may fall back, with a warning lamp. In GM's eAssist analogue the switch to sensorless current control happens within about 0.19 s, and the code is stored as Type B over two trips. No manufacturer documents P2D96 publicly. Check sensor supply and ground at the machine first. P2D93 is the high fault of Y; the series goes on with P2D97 for phase Z low, and P2D99 is the intermittent Y fault.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberD / 96

Possible causes

  • Phase Y sensor signal pulled to ground by damaged insulation high
  • Open circuit in the sensor supply or a backed-out terminal medium
  • Phase Y current sensor defective medium

Symptoms

  • Electric assist reduced or switched off
  • Stop-start suspended
  • Battery or system warning, charging may be reduced

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2D96

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication