OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2D95

Starter/Generator Phase X Current Sensor Circuit Low

P2D95 means the phase X current sensor of the starter/generator delivers a signal below the lowest value the controller accepts. The machine works as motor and as generator, so its phase currents change direction and the sensor reports signed values; GM's eAssist table, for example, uses limits of minus and plus 440 A. Low therefore does not mean little current, but an implausibly large reading in the negative direction or an output that has collapsed. Likely reasons are a signal wire shorted to ground, a lost sensor supply or a broken sensor. No manufacturer documents P2D95 publicly; in the GM analogue the U-phase low code sets below -440 A as a two-trip Type B fault. P2D92 is the high side, P2DC1 the general phase X circuit fault and P2DC2 its range check.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberD / 95

Possible causes

  • Phase X sensor signal wire shorted to ground or housing high
  • Sensor supply voltage missing because of an open wire or terminal medium
  • Current sensor output failed at the lower end of its range medium

Symptoms

  • Warning lamp after repeated detection
  • Starter/generator runs in a restricted mode with less torque
  • Stop-start unavailable

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2D95

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication