OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2D94

Starter/Generator Phase Z Current Sensor Circuit High

P2D94 completes the high-side series: the phase Z current sensor of the starter/generator outputs a value above its valid window. Inverters for 48 V starter/generators are built for three- or six-phase machines, and the controller relies on measured phase currents to set torque for engine restarts, boost and energy recovery. CARB's OBD rule requires input components, including the hybrid parts a manufacturer has to monitor, to detect wiring faults and readings outside the plausible range; a high-side code like this one is such an out-of-range finding. No manufacturer documents P2D94 publicly. Typical finds are a pinched lead or a loose plug at the machine, moisture in the electronics or a sensor defect, which often means replacing the starter/generator assembly. P2D97 is the low counterpart, P2D9A the intermittent fault.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberD / 94

Possible causes

  • Pinched sensor lead or loose plug at the starter/generator high
  • Water ingress into the machine-mounted electronics medium
  • Phase Z current sensor defective, output reads too high medium

Symptoms

  • MIL or system warning lamp
  • Stop-start and recuperation switched off
  • Battery warning because the machine charges less or not at all

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2D94

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication