OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2D92

Starter/Generator Phase X Current Sensor Circuit High

P2D92 is set when the signal from the phase X current sensor of a belt or crankshaft starter/generator rises above the range the control electronics treat as valid. Such sensors, commonly Hall devices placed around the phase conductor, put out a voltage that tracks the current, so a value stuck near the top of the scale points to the circuit rather than to real current: a signal lead touching a supply voltage, a damaged connector or a sensor whose output has failed high. No manufacturer documents P2D92 publicly. The closest published logic is GM's eAssist belt machine, coded as drive motor A: a reading above 440 A within about 42 ms, Type B over two trips, after which current control carries on without the sensors. Low side: P2D95; Y and Z: P2D93, P2D94.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberD / 92

Possible causes

  • Phase X sensor signal wire shorted to a supply or reference voltage high
  • Current sensor output failed at the upper end of its range medium
  • Damaged, corroded or water-contaminated connector at the starter/generator medium
  • Fault in the evaluation circuit of the starter/generator control module low

Symptoms

  • Warning lamp or MIL, often only after the fault has been seen on two trips
  • Reduced electric assist and weaker restarts after automatic engine stop
  • Automatic stop-start no longer active

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2D92

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication