OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2D90

Engine Oil Pressure Sensor/Switch C Circuit High

P2D90 is set when sensor C delivers a voltage above its valid range. Typical reasons are a broken ground or signal wire that lets the input float up, a short to battery voltage or a sensor with a failed output stage. No manufacturer publicly describes P2D90; for the EA888 evo5 Audi documents only the low counterpart P2D8F. Sensor A gives the yardstick: Ford's 2024 engines flag an analog sensor above 4.75 V for 5 s (P0523), and a GM 2024 engine table sets P0523 above 4.5 V after 1 s as a two-trip fault. Because the controller can no longer read real oil pressure from that sensor, it may light the oil warning or hold functions that rely on it, such as a variable oil pump, in a safe setting. Measure reference, signal and ground at the plug first. Low is P2D8F.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberD / 90

Possible causes

  • Open ground or signal wire of sensor C high
  • Signal wire shorted to battery or reference voltage medium
  • Sensor C output stage defective medium

Symptoms

  • Malfunction indicator lamp, depending on make
  • Oil pressure gauge or warning shows implausible values
  • Variable oil pump may stay in its safe stage

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P2D90

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication