OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2D8F

Engine Oil Pressure Sensor/Switch C Circuit Low

P2D8F means the signal of oil pressure sensor C lies below its valid electrical range, which usually points to a short to ground, a lost supply or a defective sensor. Audi uses the code on 2025–2026 A5, S5, Q5 and SQ5 models with the 2.0 TFSI EA888 evo5 (TSB 2079097): engine control unit J623 stores it with symptom 17004, and the cluster may show the oil pressure and emission warnings. The first release blamed the control unit calibration. The revision adds that a voltage spike from a powerful charger switched on together with the ignition can set it, so the charger is connected first, the memory cleared and no parts replaced unless the code comes back. For sensor A, Ford flags an analog signal under 0.25 V for 5 s and a GM 2024 engine table under 0.25 V for 1 s. High is P2D90.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberD / 8F

Possible causes

  • Voltage spike from a workshop charger switched on with the ignition (Audi EA888 evo5) medium
  • Signal or supply wire of sensor C shorted to ground high
  • Sensor C defective with output stuck near zero medium
  • Engine control calibration that sets the fault too readily low

Symptoms

  • Oil pressure warning without real pressure loss
  • Emission control warning lamp
  • Warning message in the instrument cluster

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P2D8F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication