OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2D86

Fuel Temperature Sensor A/B Correlation

P2D86 checks two fuel temperature sensors against each other. Where both ought to show nearly the same value, because they measure the same fuel or after a long engine-off soak, a gap larger than a calibrated margin makes the pair implausible, without telling which sensor lies. No manufacturer documents P2D86 publicly. GM runs exactly this test on direct-injection gasoline engines under its own number P111F: two SENT temperature sensors on the high-pressure rail may differ by no more than 10 °C, and 100 bad readings out of 125, one every 100 ms, set a Type B fault after two trips. Ford's 2023 diesels instead compare sensor A with the charge air cooler outlet after six hours off (P0181, 20 °C). Circuit faults of the single sensors are P0182/P0183 and P0187/P0188.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberD / 86

Possible causes

  • One of the two fuel temperature sensors has drifted and reads too warm or too cold high
  • Corroded or loose connector adding resistance to one sensor signal medium
  • Replacement sensor of the wrong type or fitted in the wrong position low
  • Engine control software with too tight a comparison limit low

Symptoms

  • Malfunction indicator lamp, usually after two drives
  • Often no noticeable change in how the engine runs
  • Occasionally rougher hot restarts if fuel quantity correction is off

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2D86

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication