OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2D80

Charging Start Switch Circuit Low

P2D80 is set when the start switch line is dragged below its valid voltage, typically through a short to ground or a contact that stays closed on a button that grounds the input when pressed. No manufacturer documents P2D80 publicly. In that common layout a grounded line reads as a start button held down forever. The risk differs from the stop switch: a stuck start request could begin charging against a timer setting or keep re-requesting a session, so the control unit is expected to set the code and stop acting on the input. Where low is instead the idle state, presses are simply lost. CARB demands that distinct out-of-range faults of such inputs get separate codes, hence this code beside P2D7F. The stop switch has its own low code, P2D7B.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberD / 80

Possible causes

  • Start switch signal wire shorted to ground high
  • Start switch contact stuck closed or bridged by moisture medium
  • Corrosion in the connector creating a path to ground low

Symptoms

  • Charging ignores the timer or starts unexpectedly before the code is set
  • Start button no longer works after the fault is detected

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2D80

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication