P2D7A
Charging Stop Switch Circuit High
P2D7A means the voltage on the charging stop switch line stays above the band the control unit accepts. This refers to the signal, not to the button position: typical causes are a broken wire or switch contact on a line held up by a pull-up resistor, or a short to a supply voltage. No manufacturer documents P2D7A publicly. What the driver notices depends on the circuit layout. If high is the idle level, an open line looks like a button never pressed, so charging can only be ended by unplugging. If the switch pulls the line up when pressed, the fault mimics a held button, the case Toyota's patent calls a closed failure, and charging will not start at all. The low counterpart is P2D7B, the start switch equivalent P2D7F.
Possible causes
- Stop switch signal wire chafed through and touching a supply voltage medium
- Open circuit in the stop switch line or connector (pull-up design) high
- Burnt or broken contact inside the stop switch medium
Symptoms
- Charging does not start although the plug is connected
- Pressing the stop button has no effect during charging
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2D7A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.