P2D79
Charging Stop Switch Circuit
P2D79 covers the circuit of a charging stop switch as a whole, a button the driver presses to end external charging before the battery is full. The code is set when the switch line carries no valid signal at all; high, low, performance and intermittent faults of the same line have their own codes P2D7A to P2D7D. No manufacturer documents P2D79 publicly. The part itself is described in patents: in Toyota's design the charging ECU receives a stop signal for as long as the button is held, and Honda's older EV charger ran until the battery was full or its stop switch was turned on. Under CARB, hybrid parts a maker chooses to monitor are judged like any other input, circuit faults included. With an unreadable stop button, the car may refuse to charge or may simply ignore the button.
Possible causes
- Loose, corroded or unplugged connector at the stop switch high
- Broken wire between stop switch and charging control unit medium
- Stop switch itself defective medium
Symptoms
- Charging cannot be ended with the stop button
- Charging may be refused as a precaution
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2D79
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.