P2D68
Battery Charging System Negative Contactor C Control Circuit High
P2D68 means the wire energising minus charging contactor C carries more voltage than commanded, for instance where it rubs on a 12 V line or the output stage keeps conducting. No manufacturer documents P2D68 publicly. GM's published tests show how such a short is judged and how the margin has tightened: for the 2011 Volt minus charge contactor (P0D11) GM calls it a short to supply once the idle output comes within 1.2 V of the supply voltage; the 2016 tables cut that margin to 0.4 V. If the coil is fed from the high side, a short can pull contactor C in without command and close the return pole while the module thinks it is open, so charging is normally locked. P2D67 is the low case, P2D61 the plus side, P2D76 contactor D.
Possible causes
- Drive wire chafed against a 12 V supply line high
- Output stage in the module no longer switches off medium
- Wires swapped or pinched after repair work low
Symptoms
- Charging blocked as a precaution
- Contactor may click without a charging request
- High-voltage or charging warning
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2D68
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.