OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2D65

Battery Charging System Negative Contactor C Control Circuit/Open

P2D65 concerns the line that drives the coil of minus-side charging contactor C: the module notices that what it commands and what the line actually shows do not match, which usually means a broken wire, a loose terminal or an open coil. No manufacturer documents P2D65 publicly. The closest published test is GM's P0D11 for the minus charge contactor of the 2011 Volt: with the output off, more than 2 V on it counts as an open load, and the code needs 40 bad samples out of 50 taken every 12.5 ms (one trip, Type A); a short to ground stays invisible to that check. P2D5E is the plus-side twin, P2D73 the same fault on contactor D. The return pole of path C cannot be closed, so that charging mode drops out.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberD / 65

Possible causes

  • Broken coil-drive wire or terminal pushed out of the connector high
  • Open winding in the coil of minus contactor C medium
  • Faulty output stage in the controlling module low

Symptoms

  • The charging mode routed through contactor C does not start
  • Code is stored even without a charging request
  • Charging fault message in the cluster

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P2D65

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication