OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2D61

Battery Charging System Positive Contactor C Control Circuit High

P2D61 points to excess voltage on the wire feeding the coil of plus-side contactor C, caused by touching a 12 V feed or by an output stage that no longer switches off. The real danger is a coil energised without command, closing the plus pole of the charging path while the module assumes it is open; charging is therefore normally inhibited. No manufacturer documents P2D61 publicly. GM's contactor A test (P0D0A) detects this as a short to battery when the switched-off output is less than 0.4 V below supply (2016 tables; the 2011 Volt minus contactor test uses 1.2 V). Audi documents the comparable high fault for contactor B (P2BCA) on Q8 e-tron models of model year 2024, but not for C. Chafed or swapped wires after repair work and a faulty driver are the usual causes. P2D60 is the low case, P2D68 the minus side.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberD / 61

Possible causes

  • Coil feed wire shorted to a 12 V supply high
  • Output stage does not switch off medium
  • Wires swapped at a connector after repair work low

Symptoms

  • Charging blocked as a precaution
  • Contactor may click without a charging request
  • High-voltage or charging warning

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P2D61

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication