P2D5C
Battery Charging System Positive Contactor C Stuck Closed
P2D5C is set when positive charging contactor C still conducts after the module commanded it to open; fused contacts are the usual reason. No manufacturer documents P2D5C publicly. Patents describe how a weld shows up: Ford opens its charge contactors one at a time after a session and treats one as welded if the voltage measured at the charger stays within a set margin of the battery voltage; one welded pole blocks further charging, both welded also block driving. GM spots a stuck contactor before start-up from the coil current of a short pulse that is too brief to close a healthy one. Because the plus pole of that charging path can stay live, the module usually locks the path. P2D5D is the reverse fault, P2D63 a welded minus contactor C, P2BC5 the contactor B twin.
Possible causes
- Main contacts of contactor C welded, e.g. after switching under load high
- Coil output stage does not switch off low
- Faulty voltage measurement on the charger side simulating a weld low
Symptoms
- Charging blocked after the previous session
- High-voltage warning, possibly no ready mode
- Code appears at the end of a charging session or at start-up
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2D5C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.