P2D56
Hybrid/EV Battery Pack Coolant Temperature Sensor C Circuit Intermittent/Erratic
P2D56 points to a coolant temperature signal from sensor C that jumps around faster than liquid in the battery loop can really change temperature, while mostly staying inside the electrical limits. No manufacturer documents P2D56 publicly. GM runs such a test for sensor A as P0C46 in table 19OBDG01: every 100 ms the step to the previous inlet reading is taken, ten absolute steps are summed, and a sum above 64 °C counts as a failure; 4 s within 5 s set a Type B code, and the test pauses while the hard faults P0C44 or P0C45 are active. For sensor B, Volvo's TJ 36929 notes that P0CD900 after charging in air above 20 °C can be a false detection cured by software 3.2.4. CARB requires circuit continuity checks. Loose pins and moving harnesses are the usual suspects.
Possible causes
- Loose or corroded terminal in the sensor C connector high
- Harness rubbing or moving with the battery, causing brief interruptions medium
- Detection logic reacting to normal conditions (software update) low
Symptoms
- Warning light that comes and goes
- Sensor C value jumps in live data, especially when wiggling the harness
- Usually no noticeable driveability change
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2D56
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.