P2D54
Hybrid/EV Battery Pack Coolant Temperature Sensor C Circuit Low
P2D54 flags the signal voltage of battery coolant temperature sensor C as too low. These sensors are NTC thermistors pulled up to a reference, so a falling voltage reads as rising temperature; a short to ground or an internally shorted sensor therefore looks like boiling coolant, while the loop itself may be cold. No manufacturer documents P2D54 publicly. GM uses the same logic for sensor A as P0C44: its battery controller fails the inlet value at 87.9 °C, an ADC count of 133 or less in the 2019 tables and 130 or less in the 2011 Volt, for 1.75 s within 2.5 s, Type B. CARB requires out-of-range checks on battery thermal inputs. Expect warnings and possibly limited power; the high counterpart is P2D55.
Possible causes
- Signal wire of sensor C shorted to ground (chafed harness) high
- Sensor C shorted internally medium
- Moisture or coolant in the connector bridging the pins low
Symptoms
- Live data shows an implausibly hot coolant reading for sensor C
- Battery cooling runs constantly
- Warning light and possibly reduced power
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2D54
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.