P2D4A
Hybrid/EV Battery Pack F Over Temperature
P2D4A covers section F, the sixth part of a battery whose controller watches temperature section by section. It pairs naturally with P0EE1, the deterioration code of the same section: aged cells with higher internal resistance turn more current into heat, and repeated overheating speeds up ageing, so both entries on one letter point at the modules themselves rather than at cooling. No manufacturer documents P2D4A publicly. How strictly a lamp follows varies even for the whole-pack code: GM's eAssist table 13OBDG05C sets P0A7E above 72.3 °C, taken from the maximum of the healthy sensors, as a Type B code with the MIL after two trips, while its plug-in tables rate it Type A. CARB requires cooling performance checks. Power is limited.
Possible causes
- Aged modules in section F producing extra heat (often with P0EE1) high
- Insufficient cooling flow to section F medium
- Sensor in section F reading too high low
Symptoms
- Warning light; timing depends on manufacturer (first or second trip)
- Shorter electric range and weaker electric drive
- Battery fan or coolant pump louder than usual
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2D4A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.