P2D42
A/C Compressor Motor Voltage B Low
P2D42 is stored when voltage B at the electric A/C compressor motor stays below the lower limit of its working range, so the inverter cannot drive the motor properly and usually switches it off. Unlike a sensor circuit code, it refers to the voltage that is actually present. No manufacturer documents P2D42 on an official public source. Mazda's bulletin 07-002/26 for the CX-90 and CX-70 plug-in hybrids shows the classic cause on the voltage A side (P0D6D): an internal short blows the A/C high-voltage fuse. GM's 2011 Volt flagged a compressor input of 190 V or less as P0D6B. A loose high-voltage connector or open contactors also fit. The A/C stops cooling; plug-in hybrids may lose battery cooling too.
Possible causes
- Blown A/C high-voltage fuse, often after an internal compressor short high
- Loose or corroded high-voltage connector at the compressor medium
- Internal fault in the compressor inverter or measurement medium
Symptoms
- A/C blows warm air
- Hybrid system warning, possibly reduced battery cooling or charging power
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2D42
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.