P2D3B
Hybrid/EV Discharge System Fault
After the contactors open, the capacitors of inverter and DC link still hold high voltage, so a discharge system, either a resistor or an active circuit in the power electronics, drains them within seconds. P2D3B is the general fault code for this system; the narrower ones are P0C75 and P0C76 for discharge time and P0EED for the discharge circuit. No manufacturer documents P2D3B publicly. GM's 2019 hybrid table shows how the drain is checked under P0C76: if the inverter still reads above 200 V 3.5 s after the main contactors opened, a Type A fault is set after two runs. Volkswagen patent US9586481B2 requests active discharge after a severe crash and treats it as complete below about 60 V. The car may refuse to restart, and nobody should work on the system without measuring that it is voltage-free.
Possible causes
- Faulty active discharge switch or driver in the inverter high
- Open or degraded passive discharge resistor medium
- Wrong high-voltage reading in the inverter or battery module medium
- Contactor that does not open, so the bus stays fed from the battery low
Symptoms
- Hybrid/EV system warning lamp on
- Vehicle does not become ready on the next start
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2D3B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.