P2D3A
Forced Hybrid/EV System Shutdown
P2D3A records that the high-voltage system as a whole was shut down by force rather than in the normal power-down sequence. Stellantis uses it in the battery pack control module (BPCM) of its 400 V STLA Large electric cars, the 2025 Dodge Charger Daytona (bulletin 08-025-25) and the 2024–2025 Jeep Wagoneer S (08-011-25, 08-128-25). In these bulletins the code is not the complaint itself: after the BPCM has been reprogrammed, the technician checks whether P1614 (ECU reset), P2D3A or U029A (lost sensor module) are present, and for P2D3A runs the BPCM Soft Reset routine in wiTECH. The code can therefore follow a module reset, a software fault or a safety reaction elsewhere. A disconnect of the battery alone is P2D39. While it is active the car may refuse to become ready.
Possible causes
- Battery control module reset or reprogramming leaving the shutdown latched (Stellantis BPCM) high
- Software fault in the battery or vehicle control module medium
- Safety reaction to another high-voltage fault, which is stored alongside medium
Symptoms
- Vehicle does not enter drive-ready mode
- Wrench or service warning in the instrument cluster
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2D3A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.