OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2D38

Hybrid/EV Battery Pack Heater Performance

P2D38 is the functional check of the traction battery heater: it was switched on, yet the pack or its coolant did not warm as expected, or the heater ran too hot. CARB asks for such a heating check wherever feasible. Toyota uses the code on the 2023 bZ4X as P2D384B, the failure type standing for over temperature; tech tip T-TT-0727-23 lists it with an illuminated MIL and asked dealers to call technical support first because the cause was still under investigation. GM's Volt shows the usual logic under its own code P1EC6: in 2011, heater on for more than 40 s with less than 9 °C rise of the pack inlet coolant; in 2014, a rise slower than 0.15 °C/s within up to 161 s while charging; both Type B over two trips. Wiring faults of heater circuits use other codes. In cold weather, charging and power may be restricted.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberD / 38

Possible causes

  • Heater element or its power switch delivering no or too little heat high
  • Air, low coolant or a weak pump so that heat does not reach the pack sensors medium
  • Pack inlet or cell temperature sensor reading wrong, faking a missing rise or overheating medium
  • Control software that judges the heating too strictly (Toyota bZ4X case under investigation) low

Symptoms

  • Malfunction indicator lamp or hybrid/EV system warning on
  • Slow charging or reduced power in cold weather
  • Battery stays cold although preconditioning was requested

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P2D38

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication