P2D36
Hybrid/EV Battery Inductive Charger Output Voltage Performance
P2D36 judges the DC side of the inductive charger: the voltage it hands to the traction battery is outside what the controller expects for the current state, too low to push charge current or above what the battery may accept. No manufacturer documents P2D36 publicly. How the vehicle side regulates this output is shown in Hyundai patent US10245962B2: the vehicle assembly rectifies the coil power with a bridge whose two switching legs change timing to raise or lower output, can shift its pad to alter coupling, and fine-tunes until the measured secondary current matches the target; the example runs at about 400 V. SAE J2954 sets the wireless power classes this must cover. Causes include a failing rectifier or filter, a drifting voltage sensor or a badly aligned car. P2D37 covers the input side. Charging is usually stopped.
Possible causes
- Faulty rectifier, switching stage or output filter in the vehicle assembly high
- Output voltage sensor drifting against the battery voltage measurement medium
- Vehicle parked off-centre over the ground pad, so the output cannot be held medium
- Regulation software of the charger module low
Symptoms
- Inductive charging stops shortly after it begins
- Charging power far below the expected value
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2D36
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.