OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2D2D

Cold Start Intake Manifold Runner Performance Bank 1

P2D2D reports that the intake manifold runner or swirl flaps of bank 1 did not reach the position the cold start strategy asked for. Many engines hold these flaps in a special setting after a cold start to stir the charge and stabilise combustion while the catalyst warms up. CARB names intake runner, charge motion and swirl valves among the features that must respond to their cold start command, robustly and beyond what they would do without the strategy. The outside-cold-start counterpart is P200A. Stellantis uses P2D2D on the 2020 Ram 1500 with the 3.0 l EcoDiesel Gen 3 and eight-speed automatic: bulletins 18-008-21 and 18-002-23 list it with P2D2E and remedy it with new PCM software. Beyond software, a stiff flap shaft, a carbon-coated runner or a weak actuator are typical reasons.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberD / 2D

Possible causes

  • Engine control software that judges the cold start flap check too strictly high
  • Flap shaft or runner coated with soot and oil deposits, stiff when cold medium
  • Worn actuator or loose linkage on bank 1 medium
  • Position sensor signal or wiring fault low

Symptoms

  • Check engine light, usually without a noticeable driving change
  • Slightly rougher idle in the first minutes after a cold start
  • P2D2E or P200A may be stored too

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2D2D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication