P2D25
Turbocharger Interstage Pressure Sensor A Circuit Intermittent/Erratic
P2D25 is set when the interstage pressure signal jumps or drops out faster than any real pressure between two turbo stages could change, typically through brief interruptions in the circuit. No manufacturer documents the code or its rate limit publicly. The sensor matters because GM's two-stage control patent feeds the measured mid-stage pressure back to the low-pressure wastegate loop, so spikes can make that loop hunt. California requires input sensors to be monitored for faults, and the boost system for slow response. Vibration and heat near the turbochargers make loose terminals and cracked insulation the leading suspects; a wiggle test while watching live data usually finds them.
Possible causes
- Loose or spread terminal in the sensor plug high
- Heat-cracked insulation causing brief shorts medium
- Moisture or oil in the connector medium
- Sensor with intermittent internal contact low
Symptoms
- Check engine light that comes and goes
- Surging or hunting boost
- Brief power loss over bumps
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2D25
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.