OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2D24

Turbocharger Interstage Pressure Sensor A Circuit High

P2D24 is the opposite case to P2D23: the interstage pressure signal is pinned near or above the top of its range. On a three-wire sensor this usually points to an open ground, a signal wire touching the 5 V reference or battery voltage, or an open signal line pulled up inside the controller. Ford's 2023 diesels, as a comparable pressure sensor example, set circuit high above 4.85 V. No manufacturer documents P2D24 or its threshold. Cummins places the sensor between the low- and high-pressure stages ahead of the charge air cooler. California requires out-of-range monitoring. A falsely high value can make the controller think the low-pressure stage overboosts and cut its output.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberD / 24

Possible causes

  • Open sensor ground or corroded ground pin high
  • Open signal wire pulled up by the controller medium
  • Signal wire shorted to 5 V reference or battery voltage medium
  • Sensor electronics failed high low

Symptoms

  • Check engine light
  • Power reduced, boost held back
  • Interstage pressure reads high even with the engine off

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2D24

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication