P2D21
Turbocharger Interstage Pressure Sensor A Circuit
Engines with two turbochargers in series can measure the pressure between the low-pressure and the high-pressure compressor. GM's patent on two-stage boost control uses this mid-stage value to split the pressure ratio between both stages and to steer the low-pressure wastegate; Cummins describes the same sensor between the stages and the intercooler. P2D21 is the general circuit code: the module rejects the signal but does not assign it to the low, high or erratic codes. No manufacturer documents P2D21 publicly. California requires input sensors to be checked for circuit faults and boost systems for under- and overboost. Single-turbo engines never set it. Expect reduced boost and power.
Possible causes
- Loose, corroded or oil-soaked sensor connector high
- Chafed or heat-damaged harness near the turbochargers medium
- Failed interstage pressure sensor medium
- Shared 5 V sensor supply faulty low
Symptoms
- Check engine light
- Reduced power, boost held to a safe value
- Sluggish response while accelerating
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2D21
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.