P2D1D
Reductant System Leak Detected - Small Leak
P2D1D reports that the pressurised DEF (AdBlue) circuit between pump, line and dosing valve loses fluid slowly, too little to collapse pressure but enough to be measurable. No manufacturer documents this code publicly. A supplier patent from Plastic Omnium shows how such leaks are found: with dosing at zero the pump should idle near 1,500 rpm at 5 bar, and a speed above 1,750 rpm raises suspicion; the line is then drawn into vacuum and a rise above -200 mbar within about 20 s confirms the leak. California requires reductant delivery to be monitored. P2D1E is the large leak, P202D the older general leakage code. Expect white crystal crusts at fittings, higher DEF use and, if ignored, an SCR warning.
Possible causes
- Seeping quick connector or damaged O-ring on the DEF pressure line high
- Worn seal or gasket at the DEF dosing valve on the exhaust pipe medium
- Hairline crack in the DEF line, often after freezing or chafing medium
- Pump module leaking internally or at its housing seal low
Symptoms
- Check engine light, usually with an exhaust service message
- White crystalline deposits at line fittings or the dosing valve
- DEF consumption noticeably higher than usual
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2D1D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.