P2D1B
Exhaust Flow Control Valve C Position Not Learned
P2D1B closes the valve C series: the control unit holds no valid end stop values for the third exhaust flap, so it cannot translate its position feedback into a reliable angle. No manufacturer documents P2D1B publicly, and so far even the A and B versions P2D11 and P2D12 are rare in published material. GM's 23OBDG07 tables show the principle for two exhaust valves: during an end stop learn phase the feedback is watched for a valve stuck at a stop, and a separate test flags end stops that were never learned after 4 seconds, with the MIL on the second trip. GM bulletin PIC6289C ties such faults to new cars and recent exhaust work and prescribes a scan tool relearn instead of new parts. Ford's 25-2144 likewise needs an alignment after fitting a new actuator.
Possible causes
- Learn run for flap C not completed after installation or repair high
- Learned end stops lost after battery disconnection medium
- Flap blocked or binding so the learn run aborts medium
- Engine software that needs an update before the learn succeeds low
Symptoms
- Check engine light shortly after exhaust or battery work
- Flap C hunting, buzzing or rattling
- Sound modes do not switch as expected
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2D1B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.