P2D1A
Exhaust Flow Control Valve C Position Circuit High
P2D1A flags an angle feedback from actuator C that sits above the top of its permitted band: an analog line close to the supply level, or a PWM return hanging near full duty. Typical reasons are a broken sensor ground, a feedback wire chafed against a live conductor, or water creeping between the connector contacts. Because an input without ground drifts up to the pull-up voltage, an open ground shows up as a high reading. No manufacturer documents P2D1A publicly. On MD1 engines Deutz logs P2BF7, the valve A twin, for excessive flap voltage or a short to positive, while GM in its 23OBDG07 tables rejects an exhaust valve return above 98 percent duty once it lasts 4 seconds, with a two-trip MIL under a GM code. In contrast to P2D15, which concerns the drive wire, the flap itself can keep moving here.
Possible causes
- Open or corroded sensor ground high
- Feedback wire touching a voltage-carrying wire medium
- Moisture or road salt in the actuator connector medium
- Position sensor in actuator C failed high low
Symptoms
- MIL on
- Control unit ignores flap C feedback and stops adjusting it
- Exhaust sound stuck in one mode
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2D1A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.