P2D19
Exhaust Flow Control Valve C Position Circuit Low
P2D19 is stored when the angle feedback from actuator C drops beneath the bottom of its permitted band. With an analog sensor the line then reads close to zero volts, mostly through a ground short or a lost 5 V supply; with a PWM return the duty cycle hangs close to zero. No manufacturer documents P2D19. The nearest public examples belong to valve A: in bulletin 01-004/20 Mazda links P2BF6 to a low reading from the shutter valve sensor on its cylinder deactivation engine, curing it with new PCM software, and Deutz MD1 engines store P2BF6 when flap voltage falls too low. In GM's 23OBDG07 tables an exhaust valve feedback under 2 percent duty cycle fails after 4 seconds. If flaps share a sensor supply, a low on several of them points to that reference rather than to sensor C.
Possible causes
- Feedback wire shorted to ground high
- Missing sensor supply voltage or open supply wire medium
- Position sensor in actuator C failed low medium
- Faulty evaluation logic in the engine software low
Symptoms
- Check engine light
- Flap C no longer adjusted, default position held
- Possible power reduction on engines that tie the flap to cylinder deactivation
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2D19
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.