OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2D18

Exhaust Flow Control Valve C Position Circuit Range/Performance

With P2D18 the position signal of flap C is electrically sound, but its value makes no sense: the reported angle lags or contradicts the command, the end points have wandered off the stored values, or the reading creeps while the flap is idle. No manufacturer publishes P2D18. GM's 23OBDG07 tables separate the two levels clearly: the raw PWM feedback is checked first, and only if it is valid is the computed valve position judged, failing below 3.5 or above 96.5 percent for 4 seconds under GM codes. Ford's 2020 Mustang GT500 bulletin 21-2011, covering the valve A and B codes P2BF5 and P2BFD, found mechanical reasons such as pinched wiring or a tailpipe bracket not welded flush. CARB also requires plausibility checks on such inputs. Unlike P2D16, the fault lies in what the sensor reports.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberD / 18

Possible causes

  • Actuator or silencer shifted so the end points no longer match high
  • Worn or drifting position sensor in the actuator medium
  • Pinched or chafed wiring causing an unsteady signal medium
  • Learned values no longer valid after parts were replaced low

Symptoms

  • MIL on after a drive cycle
  • Exhaust note changes at the wrong moment or flap C hunts
  • Drive or exhaust mode reported unavailable

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2D18

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication