P2D15
Exhaust Flow Control Valve C Control Circuit High
P2D15 is set when the drive wire of flap C carries too high a level, so the output stage cannot pull it down as commanded. Either the wire touches something live, or the electronics inside the actuator push voltage back onto it. No manufacturer publishes P2D15. Analogies exist for flaps A and B: in its 2024 OBD summary Ford books a short to power as subtype 12 of its continuous driver check, which runs for 5 seconds, while the GM 23OBDG07 tables flag the same fault on an exhaust valve PWM line as P2BFA, with more than 9 V supply once 4 seconds have passed, MIL after the second trip. CARB requires such circuit checks on output devices. A flap that keeps moving or sits fully open although nothing was requested fits this code better than P2D14.
Possible causes
- Control wire shorted to a voltage-carrying circuit high
- Defective electronics in the valve C actuator feeding voltage back medium
- Output stage in the control module stuck high low
Symptoms
- Check engine light
- Flap C open or moving without being commanded
- Exhaust sound modes unavailable
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2D15
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.