OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2D14

Exhaust Flow Control Valve C Control Circuit Low

With P2D14 the drive wire of flap C is dragged toward ground when the driver expects a higher level. Chafed insulation touching the body or the exhaust, a crushed harness after the car was jacked up, or a shorted actuator winding are the classic reasons. No manufacturer documents P2D14. For the A and B flaps, the Ford 2024 OBD summary handles a ground short as subtype 11 of its smart driver check, run over a 5 second window, and GM's 24OBDG07 tables store P2BF9 for a grounded exhaust valve PWM line after 4 seconds once the supply exceeds 9 V, lighting the MIL on the second trip. CARB wants actuator circuits checked for values outside their range. As the wire is intact but shorted, a continuity test can pass; check the insulation to ground along the whole run instead.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberD / 14

Possible causes

  • Control wire chafed through and touching ground high
  • Shorted winding or electronics in the valve C actuator medium
  • Water or salt bridging pins in the connector low

Symptoms

  • MIL on
  • Flap C does not move or stays at its default angle
  • Exhaust louder or quieter than the selected mode

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2D14

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication