OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2D12

Exhaust Flow Control Valve B Position Not Learned

P2D12 is the counterpart of P2D11 for the second flap or bank 2: the stored end positions of exhaust valve B are missing or were rejected. No manufacturer documents P2D12 publicly. The closest public logic sits in GM's 23OBDG07 table, which decides from the PWM feedback of exhaust valve 2 whether its end stops have been learned, over 4 seconds with more than 9 V on board, as a two-trip fault under its own code P3181. Ford needs the same alignment on the 2023-2025 F-150 with supercharged 5.2 L V8 (bulletin 25-2144) if the B monitor status PID shows 3, yet stores P2BF8 subtype 78 or P2BFB for it. GM bulletin PIC6289C warns that a disconnected battery can force a relearn. A scan tool learn run usually cures it; if it fails again, the flap or its mounting binds.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberD / 12

Possible causes

  • Alignment or learn run for valve B skipped after repair high
  • Adaptation erased by a discharged or disconnected battery medium
  • Actuator mounted out of position or flap shaft binding medium
  • Outdated engine software that makes the learn fail low

Symptoms

  • MIL on, sometimes with an exhaust mode not available message
  • Flap B noisy or searching for position
  • No audible change between sound modes on one side

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2D12

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication